HWI 1/8"-FPT BRASS LAMP CAP NUTS JWH 522777
Hold bent glass shades onto ceiling light fixtures with these brass finish 1 in lock-up caps. A brass finish and floral design on these two caps add a polished, decorative touch to any fixture. These caps have a 1 in diameter and are tapped 1/8-IP, so theyll meet the needs of common repair and restoration projects.
-
BrandWestinghouse
-
UPC030721701597
-
Manufacturer Part Number7015900
-
CountryUSA
-
FinishBrass Plated
-
MaterialMetal
-
Dimensions1 in Dia
-
Specifications1/8-IP Tapped
-
Suitable For Use WithCeiling Light Fixture
- Brass finish for traditional look
- Floral design
| Cross-Reference Number |
|---|
| 522777 |
-
UNSPSC31161736
-
Package DescriptionEACH
-
Standards/ApprovalsPROP65: Warning: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Recently Viewed
Hold bent glass shades onto ceiling light fixtures with these brass finish 1 in lock-up caps. A brass finish and floral design on these two caps add a polished, decorative touch to any fixture. These caps have a 1 in diameter and are tapped 1/8-IP, so theyll meet the needs of common repair and restoration projects.
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Drillco 72A148C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 3/4 in Dia Cutter, 1-1/2 in Length of Cut, 2 Flutes, 3/4 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
Irwin® WeldTec™ 3043012 Ship Auger Bit, 15/16 in Dia, 17 in OAL, 12 in L Hollow Center Flute, 7/16 in Shank
The IRWIN with WeldTec ship auger is made stronger and lasts longer than any standard augers. It features a welded cutting edge that easily cuts through tough materials like nail-embedded wood. It has twice the nail cutting life of standard ship augers. With an aggressive screw-pitch for fast drilling, this bit is fully-forged for durability, and wide flutes provide chip removal with less binding.
MALE DISCONNECT CONNECTOR--PK/100-PENMT4B187C >
2.313" X 2.997" X .375" OIL SEAL - CHI23030>
