Leviton® 70045 1-Circuit 1-Piece Keyless Lampholder, 660 W Lamp, 600 V AC, E26 Lamp
Leviton® 70045 1-Circuit 1-Piece Keyless Lampholder, 660 W Lamp, 600 VAC, Medium HID/Incandescent Lamp
-
BrandLeviton®
-
UPC078477106105
-
Manufacturer Part Number70045
-
CountryUSA
-
FinishGlazed
-
Terminal TypeLead Wire
-
MaterialPorcelain
-
ColorWhite
-
Type1-Circuit 1-Piece Keyless
-
Connection TypeSide Wired
-
Mounting TypeBushing
-
Voltage Rating600 V AC
-
Dimensions1.48 in Dia x 1.69 in L
-
Lamp Base TypeE26
-
Lamp TypeHID/Incandescent
-
Lamp Wattage660 W
- 1-piece construction
- 4 kV pulse rated
- Single circuit lampholder
- Nickel plated copper alloy screw shell and contact
- Leaf spring center coil spring
- (2) 6-32 bushing
-
Alternative Part Number7342453
-
UNSPSC39111803
-
IDEA Index ID7342453
-
Package DescriptionEACH
-
Standards/ApprovalsUL File No. E3810|CSA File No. LR1863
-
Warranty1 Year Limited
-
Specification Sheet
Recently Viewed
Leviton® 70045 1-Circuit 1-Piece Keyless Lampholder, 660 W Lamp, 600 V AC, E26 Lamp
Leviton® 70045 1-Circuit 1-Piece Keyless Lampholder, 660 W Lamp, 600 VAC, Medium HID/Incandescent Lamp
Browning® offers an extensive multi-groove sheave offering. This includes Browning® Split-Taper® and QD® bushing designs. This means maximum economy and versatility for your application. Truly the right drive every time our exclusive B5V® sheaves have a patented design that offers 5V horsepower in the economy of a B section sheave. B5V® sheaves serve 90% of all applications from 10 to 150 hp. This can reduce cost up to 40% over traditional designs.
Leviton® 13351-D Standard Lampholder, 660 W Lamp, 600 VAC, Medium Bi-Pin Fluorescent Lamp
BBI 221049 Shoulder Screw, Round Socket Head, ASTM A574 Alloy Steel, 3/8 in Dia x 3/8 in L Shoulder, 5/16-18
BBI 221049 Shoulder Screw, Round Socket Head, ASTM A574 Alloy Steel, 3/8 in Dia x 3/8 in L Shoulder, 5/16-18
Koyo IR-2424 Inch Series Regular Width Inner Ring, 1-1/2 in ID x 1-3/4 in OD, 1.515 in OAW, For Use With Inch Series Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
