Tungsten Carbide Burr, 1/4" Tree Pointed (sg-1) FOR60126
TUNGSTEN CARBIDE BURR, 1/4" TREE POINTED (SG-1) WITH 1/4" SHANK. MAXRPM: 70.000. SHANK MOUNTED TUNGSTEN CARBIDE BURRS ARE DOUBLE CUT FOR FINE WORK
Recently Viewed
TUNGSTEN CARBIDE BURR, 1/4" TREE POINTED (SG-1) WITH 1/4" SHANK. MAXRPM: 70.000. SHANK MOUNTED TUNGSTEN CARBIDE BURRS ARE DOUBLE CUT FOR FINE WORK
ASP-112-2-S Industry Standard Clamping Collar, 2-Piece Construction, 1-3/16 in ID x 2-1/16 in OD x 1/2 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
Square-D 30-AMP 3-POLE 208/240-V CONTACTORS SQU 8910-DPA-33-V-09
8910DP definite purpose magnetic contactors are designed for heating, air conditioning and refrigeration applications. This line of definite purpose contactors has current ratings up to 120 amperes resistive and 50 HP at 600 VAC. This three pole definite purpose contactor has a full load rating of 30 ampere and a resistive rating of 40 amperes. It also has a 2 HP at 115 VAC single phase, 5 HP at 230 VAC single phase and 10 HP at 230 VAC three phase, 15 HP at 460 VAC three phase and 20 HP at 575 VAC three phase. The nonreplaceable coil is available with a variety of coil voltages. This device has a 208/240 VAC 60 Hz, 220 VAC 50 Hz coil. The contactor has straight through wiring. Contactor is 3.75 inches by 2.37 inches and 3.00 tall. These contactors are UL component recognized and CSA certified.
Reelcraft 50' 16/3 1-OUTLET EXT/CORD REELS REC L-4050-163-3
The heavy duty series 4000 cord reels are all steel construction and compact for a wide range of applications with critical space requirements. A robust collector ring assures maximum conductivity current flow. Guide arm adjusts to two positions.
Dichtomatik N70124 O-Ring, 124 Dash Number, 1.237 in ID x 1.443 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
14-1/2" TO 29-1/2" SIDE WIND TRAILER JACK - HBC158151 >
