Enerpac® P-462 P-Series ULTIMA 2-Speed 2-Stage Hydraulic Hand Pump, 453 cu-in Tank
Enerpac® P-462 P-Series ULTIMA 2-Speed 2-Stage Hydraulic Hand Pump, 453 cu-in Tank
-
BrandEnerpac®
-
UPC662005107506
-
Manufacturer Part NumberP-462
-
CountryUSA
-
Port Size3/8-18 NPTF
-
Pressure Rating10000 psi (2nd Stage)
-
Fluid TypeOil
-
Type2-Speed 2-Stage
-
SeriesP-Series ULTIMA
-
Overall Height10.63 in
-
Overall Length29-15/64 in
-
Overall Width12-1/8 in
-
Tank Capacity453 cu-in
- Enerpac® high pressure ULTIMA hydraulic steel hand pumps are the solution for tough jobs
-
UNSPSC40151500
-
Package Description1/PK
-
Instruction/Installation Manual
-
Catalog
-
Specification Sheet
-
Warranty Information
Recently Viewed
Enerpac® P-462 P-Series ULTIMA 2-Speed 2-Stage Hydraulic Hand Pump, 453 cu-in Tank
Enerpac® P-462 P-Series ULTIMA 2-Speed 2-Stage Hydraulic Hand Pump, 453 cu-in Tank
1" X 144" 2-PLY TWISTED-EYE NYLON SLING - SWC11221 >
Dodge® 069423 Imperial Pillow Block Roller Bearing Unit, 3-7/16 in Dia Bore, 9.38 to 10.63 in L Bolt Center-to-Center, 3-3/4 in Base to Bore Centerline, 13 in OAL x 7-1/2 in OAH
Dodge® imperial spherical roller bearings are the only high-capacity double-row spherical roller bearings with an effective easy-on, easy-off adapter mounting and removal system. Not only does this patented system provide a concentric grip for superior holding on the shaft, but it reduces the fretting corrosion caused by traditional setscrews and vibration.
Drillco 77A132C 7700 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
MORSE® 44656 4596 Center Cutting Regular Length Single End Roughing End Mill, 5/8 in Dia Cutter, 1-5/8 in Length of Cut, 4 Flutes, 5/8 in Dia Shank, 3-3/4 in OAL, Bright
Drillco 76A112C 7600 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 3/16 in Dia Cutter, 5/8 in Length of Cut, 2 Flutes, 3/16 in Dia Shank, 2-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
