Electrical Plugs
511583 DO-IT-BEST/HWI PRODUCTS
YELLOW ARMORED 20A/250V ELECTRICAL CONNECTOR - JWH511583 >
512181 DO-IT-BEST/HWI PRODUCTS
YELLOW 15A/250V ARMORED MALE ELECTRIC PLUG - JWH512181 >
LEVITON 60-AAMP 3-PHASE 48-VOLT PIN PLUGS LEV 460-P-7-W
60-AMP 3-PHASE 48-VOLT PIN & SLEEVE PLUG - LEV460P7W>
LEVITON CLEAT-TYPE LAMPHOLDER SOCKET LEV 19062
CLEAT-TYPE LAMP HOLDER SOCKET-LEV19062>
LEVITON MOGUL BULB PORCELEIN SOCKETS LEV 8756
MOGUL BASE, ONE-PIECE WHITE, KEYLESS, HID, GLAZED PORCELAIN LAMP HOLDER, HPS UP TO 400W, SINGLE CIRCUIT, BACK WIRED 4KV-PULSE RATED-LEV8756 >
LEVITON PORCELEIN LAMPHOLDERS LEV 29816-C
WHITE MEDIUM BASE ONE PIECE GLAZED PORCELAIN OUTLET BOX MOUNT INCANDESCENT LAMP HOLDER, 660W/250V, PULL CHAIN, SINGLE CIRCUIT, TOP WIRED 513796-LEV29816C >
LEVITON SLIDE-ON FIXED BASE FOR POWER GRV LEV 13557
SLIDE-ON FIXED BASE FOR POWER GRV-LEV13557>
LEVITON WHITE FLUORESENT LAMPHOLDERS LEV 464
WHITE STANDARD FLUORESCENT LAMP HOLDER, HIGH-OUTPUT BASE, DOUBLE CONTACT HORZ, PEDESTAL, SCREW MOUNT, PLUNGER, 2" SCREW TERMINAL.-LEV464 >
Recently Viewed
White-Rodgersâ„¢ 50A55-3797 Replacement Integrated Furnace Control, 25 V AC, 0.45 A
The 50A55-3797 is an automatic gas interrupted ignition control that employs a microprocessor to continually monitor, analyze, and control the proper operation of the gas burner, inducer, and fan. signals interpreted during continual surveillance of the thermostat and flame sensing element initiate automatic ignition of the burner, sensing of the flame, and system shutoff during normal operation. these controls incorporate system fault analysis for quick gas flow shutoff , coupled with automatic ignition retry upon sensing a fault correction. it is designed as a replacement for the following controls.
4"-SQUARE 1/2"-RAISED SURFACE COMBINATION EXPOSED WORK COVER - APL8375 >
The three-way pull chain socket can be used to replace a worn or broken socket or to build an entirely new light fixture. This socket pairs with a three-way bulb to offer three light levels. The pull chain switch is well suited to floor or table fixtures and its brass finish lends a classic look and effectively withstands heat. Thanks to its straight bracket design, installation is easy. UL listed and CSA approved for safety, it is rated for 250 W maximum and 250 V. The 2-1/4 in H socket has a tapped 1/8-IP bushing and uses medium base bulbs.
