460-P-7-W LEVITON ELECTRICAL PRODUCTS
60-AMP 3-PHASE 48-VOLT PIN & SLEEVE PLUG - LEV460P7W>
Recently Viewed
60-AMP 3-PHASE 48-VOLT PIN & SLEEVE PLUG - LEV460P7W>
Channellock® 356 Non-Insulated Standard End Cutting Plier, 0.056 to 0.091 in Piano Wire Cutting, 0.35 in, 6-1/4 in OAL, Plastic Handle
CHANNELLOCK® High Leverage End Cutting Pliers feature Xtreme Leverage Technology (XLT™) which makes cutting easier than ever. By positioning the rivet closer to the cutting edge, considerably less force is required to cut than other high leverage designs. State-of-the-art laser heat treating offers a strong and consistent pattern across the cutting edge for increased strength and longevity. These pliers also offer a slimmer, lighter, and better-balanced design for maximum performance and accessibility. CHANNELLOCK® End Cutting Pliers are made in USA and forged from high carbon U.S. steel that is specially coated for ultimate rust prevention.
Dichtomatik N70135 O-Ring, 135 Dash Number, 1.925 in ID x 2.131 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Lasco® 852-030 1-Piece Solid Flange, 3 in Nominal, PVC, Thread Connection, 150 lb, 7-1/2 in OD, Domestic
Lasco® 852-030 1-Piece Solid Flange, 3 in Nominal, PVC, Thread Connection, 150 lb, 7-1/2 in OD, Domestic
CONS MI-20-N MI Needle Roller Bearing, 1-1/4 in Dia Bore, 1-1/2 in Dia Outside, 1 in W
CONS MI-20-N MI Needle Roller Bearing, 1-1/4 in Dia Bore, 1-1/2 in Dia Outside, 1 in W
Dichtomatik N70347 O-Ring, 347 Dash Number, 4.225 in ID x 4.645 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
