70-231 Armstrong Tools 1/4" X 4-1/4" Center Punches
1/4" X 4-1/4" CENTER PUNCH-ARS70231 >
Recently Viewed
1/4" X 4-1/4" CENTER PUNCH-ARS70231 >
Browning® 767783 VPE 100 Intermediate Duty High Base Pillow Block Ball Bearing Unit, 7/8 in Dia Bore, 3-11/16 to 4-9/16 in L Bolt Center-to-Center, 1-7/16 in Base to Bore Centerline, 5-1/2 in OAL x 2-13/16 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric or BOA concentric locking collar. The contact seal with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction.
Makita 743206-A Durable Cup Brush, 6 in Dia Brush, 5/8-11 in Arbor Hole, Steel Fill
Makita 743206-A Durable Cup Brush, 6 in Dia Brush, 5/8-11 in Arbor Hole, Steel Fill
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
United Abrasives-SAIT 02701 End Brush, 1 in Dia Brush, Full Cable Twist Knot, 0.02 in Dia Filament/Wire, Carbon Steel Fill, 1 in L Trim
Nice® 5875VMF53 5000® Round Bore Unground Flanged Radial Ball Bearing, 3/4 in Dia Bore, 2 in OD, 1 Row, 0.572 in W, 757 lb Load
The 5000® Series of bearings is similar in construction to the 400® Series bearing except it has a flange on the outer ring to locate the bearing when pressed into a tube or housing, thus eliminating the need for an external mounting device. The bearings are designed for moderate loads and speeds where running accuracy and noise level requirements do not warrant the more expensive precision ground bearings. This series of bearings feature a full ball complement without a retainer. The rings are case hardened and the soft steel band on the outer ring of the unitized assembly allows the bearing to be pressed into a housing without the necessity of close housing tolerances. The bearings are supplied pregreased as a standard. The bearings are designed for use in applications with speeds not exceeding 1200 rpm.
