KLEIN TOOLS K-21 1/16'' Slotted Screw Holding Screwdriver
Split-blade screw-holding driver wedges into screw slot.
Positive gripping action holds, starts, and drives slotted screws in awkward, hard-to-reach places.
Not designed for torquing or tightening.
Precision blade for use with small precision screws. Blade thickness of .028'' (1 mm) expanding to .045'' (1 mm).
Has pocket clip.
Recently Viewed
Split-blade screw-holding driver wedges into screw slot.
Positive gripping action holds, starts, and drives slotted screws in awkward, hard-to-reach places.
Not designed for torquing or tightening.
Precision blade for use with small precision screws. Blade thickness of .028'' (1 mm) expanding to .045'' (1 mm).
Has pocket clip.
1" RUBBER DUST PLUGS-DXN16008>
18" YELLOW PUSH BROOM (HEAD ONLY) - MAG1918HEAD >
Bussmann Bulletā¢ ECSR300 Current Limiting Time Delay Fuse, 300 A, 600 V, 200 kAIC Interrupt, RK5 Class, Cartridge Body
Edison's UL Class RK5 dual-element, time-delay fuses provide economical solutions to overcurrent protectioni. Available in both 250Vac and 600Vac, with 200kA RMS Sym interrupting ratings and sizes ranging from 0 to 600 amp.
LevitonĀ® DustguardĀ® 2547 1-Phase Grounding Cable Mount Locking Connector, 125 V AC, 15 A, 2 Poles, 3 Wires, Yellow
LevitonĀ® DustguardĀ® line of industrial grade plugs and connectors feature rugged construction that resists impact, sunlight, chemicals and rough use. All contacts are solid 1-piece construction for superior conductivity. They are engineered to IP44 splashproof and dust tight standards. The ergonomic, fluted body design with radial gripping edge is ideal for gripping and pulling. The unique cord clamp accepts a wide range of cord sizes, providing a secure grip without damaging the cord. And, they are backed by a limited lifetime warranty.
Koyo TRC-2435 Double Direction Thrust Washer, 38.1 mm ID x 55.55 mm OD, 2.41 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
