1012 LUFKIN MEASURING PRODUCTS
1/2" X 12' TAPE MEASURE-LUF1012>
Recently Viewed
1/2" X 12' TAPE MEASURE-LUF1012>
Greenlee® Kwik Cycle® 45505G Interchangeable Die Manual Wire Crimping Tool With Die, 22 to 8 AWG Cable/Wire
RIDGID® 45505 Support Arm, For Use With: Model 1822-I/300 COMPACT Pipe and Bolt Threading Machine and Model 360 Cutter
7-PIECE INSULATED NUT DRIVER SET-GRN02570I>
Tool Set includes two nut drivers (Cat. No. 610-1/4 and 610-5/16). Full hollow shank for long bolts or studs. Stubby nut drivers allow for work in close quarters. Color-coded handles for easy identification. Meets or exceeds applicable AMSE / ANSI specifications.
Each heater is identified by a catalog number stamped on one terminal. The heater application table indicates the range of full load motor current to which a given heater may be applied. Heaters should be selected on the basis of the actual full load current and service factor as shown on the motor nameplate or in the manufacturer's published literature. When motor and overload relay are in the same ambient and the service factor of the motor is 1.15 to 1.25, select heaters from the heater application table. If the service factor of the motor is 1 or there is no service factor shown or a maximum of 115% protection is desired, select one size smaller heater than indicated.
1/2" X 10' TAPE MEASURES
