Bussmann Edison ECNR4 Current Limiting Time Delay Fuse, 4 A, 250 V AC/125 V DC, 200 kAIC Interrupt, RK5 Class
Edison's UL Class RK5 dual-element, time-delay fuses provide economical solutions to overcurrent protectioni. Available in both 250Vac and 600Vac, with 200kA RMS Sym interrupting ratings and sizes ranging from 0 to 600 amp.
-
BrandEdison
-
UPC782634507208
-
Manufacturer Part NumberECNR4
-
CountryUSA
-
Terminal TypeFerrule End
-
MaterialFiberglass
-
ClassRK5
-
Response Time8 s at 500%
-
TypeCurrent Limiting Time Delay
-
Voltage Rating250 V AC/125 V DC
-
Amperage Rating4 A
-
SeriesECNR
-
Indicating/Non-IndicatingNon-Indicating
-
Interrupt Rating200 kAIC
-
Body Size0.56 in Dia x 2 in L
-
ElementDual
- Superior overload and cycling capabilities
-
UNSPSC39121606
-
IDEA Index ID11197124
-
Package DescriptionEACH
-
Standards/ApprovalsCE Certified|CSA C22.2|UL Listed
-
Catalog
-
Specification Sheet
Recently Viewed
Bussmann Edison ECNR4 Current Limiting Time Delay Fuse, 4 A, 250 V AC/125 V DC, 200 kAIC Interrupt, RK5 Class
Edison's UL Class RK5 dual-element, time-delay fuses provide economical solutions to overcurrent protectioni. Available in both 250Vac and 600Vac, with 200kA RMS Sym interrupting ratings and sizes ranging from 0 to 600 amp.
Bussmann Bullet™ ECSR125 Current Limiting Time Delay Fuse, 125 A, 600 V, 200 kAIC Interrupt, RK5 Class, Cartridge Body
Edison's UL Class RK5 dual-element, time-delay fuses provide economical solutions to overcurrent protectioni. Available in both 250Vac and 600Vac, with 200kA RMS Sym interrupting ratings and sizes ranging from 0 to 600 amp.
United Abrasives-SAIT 27110 Mounted Point, B52, 3/8 in Dia x 3/4 in L Head, 1/8 in Dia Shank
United Abrasives-SAIT 27086 Mounted Point, A36, 1-5/8 in Dia x 3/8 in L Head, 1/4 in Dia Shank
Browning® 1069251 Type G Split-Taper Bushing, 20 mm Dia Bore, 1.133 in Dia Small End/1.172 in Dia Large End Dia Barrel, 2 in Dia Flange, 1 in OAL, Sintered Steel
External key provides positive drive with no torque on the cap screws. We offer high torque carrying capacity. Double split barrel improves true concentricity. The shaft is gripped with positive clamp fit.
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
