BBI 087146 Partially Threaded Cap Screw, 3/8-16, 2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 087146 Partially Threaded Cap Screw, 3/8-16, 2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
-
BrandBBI
-
Manufacturer Part Number087146
-
CountryUSA
-
FinishZinc CR+3
-
Tensile Strength120000 psi
-
MaterialCarbon Steel
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade5
-
Hardness25 to 34 HRC
-
Head Size15/64 in H
-
Head TypeHex
-
Shank Size3/8 in
-
Diameter - Thread Size3/8-16
-
Length Under Head2 in
-
UNSPSC31161501
-
Package Description100/CS
Recently Viewed
BBI 087146 Partially Threaded Cap Screw, 3/8-16, 2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 087146 Partially Threaded Cap Screw, 3/8-16, 2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
Enerpac® Flat-Jac® RCS-201 Low Height Single Acting Spring Return Hydraulic Cylinder, 20 ton Capacity, 2.38 in Dia Bore, 1-3/4 in L Stroke, 3.88 in H Retract, 2 in Dia Rod, 10000 psi
Enerpac® Flat-Jac® RCS-201 Low Height Single Acting Spring Return Hydraulic Cylinder, 20 ton Capacity, 2.38 in Dia Bore, 1-3/4 in L Stroke, 3.88 in H Retract, 2 in Dia Rod, 10000 psi
NIBCO 75-102-01 2-Piece Ball Valve, 3/8 in Nominal, FNPT End Style, Bronze Body, Standard Port, MPTFE Softgoods, Domestic
This Apollo™ Ball Valve meets OSHA standards and provides for easy, safe maintenance of pneumatic tools. Valve can be padlocked in the OPEN or CLOSED position with the same hardware.
BBI 042150 Partially Threaded Cap Screw, 3/8-16, 2-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042150 Partially Threaded Cap Screw, 3/8-16, 2-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
GENERAL® 370-2 Horseshoe Magnet, 1-1/8 in W
