Porter-Cable 7" ANGLE ELEC/GRINDERS POR 7410
The Power-Stud anchor is a fully threaded, torque-controlled, wedge expansion anchor. It is available in threaded, rod hanger and tie-wire versions suitable for applications in solid concrete and grout-filled concrete masonry. The carbon steel threaded version is suitable for a variety of applications. The drill bit diameter necessary for proper installation is the same as the anchor diameter.
-
BrandDeWALT®
-
UPC075352074108
-
Manufacturer Part Number7410
-
CountryUSA
-
FinishZinc Plated
-
Tensile Strength1920 lb
-
Thread Length1-1/4 in
-
MaterialCarbon Steel
-
Thread Size3/8-16
-
Thread TypeUNC
-
Minimum Embedment Depth1-5/8 in
-
Head TypeThreaded Stud
-
Shear Strength3560 lb
-
Diameter3/8 in
-
Drill Size3/8 in
-
Overall Length2-1/4 in
- Fully threaded, heavy and medium duty all-purpose anchor
- Nominal drill bit diameter same as anchor diameter
- Length id stamped on each threaded anchor
- Anchors can be installed through the fixture, hole spotting not required
- Chamfered impact section prevents damage to threads
- Length of holes can be over-drilled or bottomless
- Clip design prevents spinning during installation
- Normal weight concrete, structural light weight concrete and grouted concrete masonry are applicable materials
- 3760 lb at 4000 psi and 6000 psi shear strength for concrete
- 3040 lb at 4000 psi and 6000 psi tensile strength for normal-weight concrete
-
UNSPSC31162102
-
Standards/ApprovalsASTM E488|UL Listed
Recently Viewed
The Power-Stud anchor is a fully threaded, torque-controlled, wedge expansion anchor. It is available in threaded, rod hanger and tie-wire versions suitable for applications in solid concrete and grout-filled concrete masonry. The carbon steel threaded version is suitable for a variety of applications. The drill bit diameter necessary for proper installation is the same as the anchor diameter.
1/2" -FEMALE PIPE THREAD FULL PORT BALL VALVE-NIBT5851/2 >
The Tapper® anchoring system is a family of screw anchors, specially designed drill bits and installation tools designed to meet the needs of most light to medium duty applications in concrete, block and brick. The Tapper® concrete screw anchor is produced in either hex washer head or Phillips flat head styles from Perma-Seal™ coated or zinc plated carbon steel and type 304 stainless steel. For heavy duty applications, the 3/8 in size is made in zinc plated carbon steel.
SELECTA® ST-4-BG Tongue Spade Fork, 12 to 10 AWG Conductor, 1.01 in L, Butted Seam/Funnel Entry/Standard Barrel, Yellow
FREUDENBERG Simmering® 75022419 B1 Single Lip Oil Seal, 32 mm ID x 45 mm OD, 7 mm W, NBR Lip, 72 Durometer, Import, Transcom 45X72X7-TC
FREUDENBERG Simmering® 45X72X7TC-BX B1 Single Lip Oil Seal, 32 mm ID x 45 mm OD, 7 mm W, NBR Lip, 72 Durometer, Import
STURDY PLASTIC, DRAWSTRING CLOSURE. 30 GAL. CAPACITY
-JWH602508>
