Black&Decker 120-VOLT 4-1/2" GRINDERS BD- 2750
The Tapper® anchoring system is a family of screw anchors, specially designed drill bits and installation tools designed to meet the needs of most light to medium duty applications in concrete, block and brick. The Tapper® concrete screw anchor is produced in either hex washer head or Phillips flat head styles from Perma-Seal™ coated or zinc plated carbon steel and type 304 stainless steel. For heavy duty applications, the 3/8 in size is made in zinc plated carbon steel.
-
BrandDeWALT®
-
Manufacturer Part Number2750
-
CountryUSA
-
FinishBlue Perma-Seal
-
MaterialCarbon Steel
-
Thread Size#11-16
-
Thread TypeUNC
-
Head Drive TypePhillips®/Slotted
-
Head Size9/64 in H x 3/8 in OD
-
Applicable MaterialsNormal-Weight Concrete/Lightweight Concrete/Grouted Concrete Masonry/Hollow Concrete Masonry (CMU)/Solid Brick Masonry/Wood
-
SeriesTapper®
-
Diameter3/16 in
-
Drill Size5/32 in
-
Overall Length3-3/4 in
- High-low thread design
- Good corrosion protection with perma-seal coating
- NO 2 Phillips driver
- 1/4 in fixture clearance hole
-
UNSPSC31161502
-
Package Description100/BX
-
Standards/ApprovalsASTM E488
-
Specification Sheet
Recently Viewed
The Tapper® anchoring system is a family of screw anchors, specially designed drill bits and installation tools designed to meet the needs of most light to medium duty applications in concrete, block and brick. The Tapper® concrete screw anchor is produced in either hex washer head or Phillips flat head styles from Perma-Seal™ coated or zinc plated carbon steel and type 304 stainless steel. For heavy duty applications, the 3/8 in size is made in zinc plated carbon steel.
12-TOOTH #40-1 CHAIN SPROCKETS IDC 40-B-12-F-5/8
12 TOOTH SPROCKETS FOR #40 CHAIN
5-MM-PITCHX375-MM TIMING BELT-JAS3755M20 >
DuMONT Minute Man® replacement shims for use with Keyway Broaches are available for spares and to replace lost or damaged shims. The smallest Broaches cut in one pass and require no shim. Multiple pass Keyway Broaches are furnished with all necessary shims unless otherwise noted. Progressive shims may be purchased for use with our largest Keyway Broaches. A shim is required to compensate for the thickness removed following a Keyway Broach's cutting pass. The addition of a shim serves to move the Broach forward towards its standard finished cutting depth. Subsequent passes require the stacking of shims. Replacement or extra shims are provided in shim sets corresponding to the Broach size and letter designation in the quantity necessary to cut to standard depth. Please specify EDP number when ordering replacement or extra shims.
ECCENTRIC LOCKING BEARING COLLAR-CHIS1108K >
5-GRV BANDED 3-V X-530 V-BELT-GAT5/3VX530 >
