MORSE C/Tool 1/4"-20 USS S/POINT 2-FL PLUG TAPS MCT 33003
MORSE® 33003 2047 General Purpose Standard Spiral Point Tap, Right Hand Cutting, 1/4-20 Thread, H3 Thread Limit, Plug Chamfer, 2 Flutes, Bright, HSS
-
BrandMORSE®
-
UPC686125330033
-
Manufacturer Part Number33003
-
CountryUSA
-
Finish/CoatingBright
-
Thread Length1 in
-
MaterialHSS
-
Thread LimitH3
-
Thread Size1/4-20
-
Thread StandardGround/UNC
-
Chamfer TypePlug
-
Measurement SystemImperial
-
TypeGeneral Purpose Standard
-
Series2047
-
Number of Flutes2
-
Cutting DirectionRight Hand
-
Overall Length2-1/2 in
- Spiral point taps are designed for machine tapping in through holes in a wide variety of materials
- The point ejects the chips ahead of the tap, eliminating chip disposal problems and thread damage
- Shallower flutes also result in greater tap core strength allowing for higher cutting speeds
-
UNSPSC23241615
-
Package Description1/PK
-
Standards/ApprovalsISO 9001:2008
-
Catalog
Recently Viewed
MORSE® 33003 2047 General Purpose Standard Spiral Point Tap, Right Hand Cutting, 1/4-20 Thread, H3 Thread Limit, Plug Chamfer, 2 Flutes, Bright, HSS
Minimum Number of Clips: A minimum of 3 clips must be applied to securely form a wire rope eye or termination loop. Torque Requirement: The nuts must be tightened evenly to a minimum torque of 95 ft-lbs to prevent cable slippage .Rope Turn-Back: You must allow for exactly 12 inches of cable turn-back from the base of the eye to ensure adequate length for clip placement. Efficiency Rating: Properly installed clips on 9/16" wire rope yield an 80% efficiency rating based on the catalog breaking strength of the wire rope.
48" RIVET-RITE CENTER SUPPORTS-PNC46CS42 >
7/8"-ID HIGH PILLOW BLOCK UNITS-MBUVPS214>
COMPRESSION SPRINGS-WBJ9 >
CORD CONNECTOR-JWH544892 >
