Drillco 31E030AB 3100E Adjustable Round Split Die, M3.0x0.5 Thread, 1 in OD Die, HSS
The round split adjustable die may be adjusted through the screws on the holder. Adjustment on the open type is done by turning the three screws on the holder. A die holder or handle is needed for proper operation of round split adjustable dies.
-
BrandDrillco
-
UPC045996996357
-
Manufacturer Part Number31E030AB
-
CountryUSA|Canada
-
FinishUncoated
-
Thread DirectionRight
-
MaterialHSS
-
Thread SizeM3.0x0.5
-
Measurement SystemMetric
-
TypeAdjustable
-
Series3100E
-
Die Outside Diameter1 in
- Adjustable screws for microadjustment to fit slightly different diameter sizes
- Bright finish for smooth operation
- Outer Diameter is designed to be used with Drillco die stocks
- Outer Diameter is designed to be used with Drillco die stocks
-
UNSPSC27112805
-
Package Description1/PK
-
SDS
-
Catalog
Recently Viewed
Drillco 31E030AB 3100E Adjustable Round Split Die, M3.0x0.5 Thread, 1 in OD Die, HSS
The round split adjustable die may be adjusted through the screws on the holder. Adjustment on the open type is done by turning the three screws on the holder. A die holder or handle is needed for proper operation of round split adjustable dies.
HCI Preferred Supplier 10002 Long Rod Nut, 3/16 in Nominal, SAE Flare Threaded UNF, Brass
HCI Preferred Supplier 10002 Long Rod Nut, 3/16 in Nominal, SAE Flare Threaded UNF, Brass
1/2" -13" USS TAPER HAND TAP-PDTEK508133T >
IKO LRT151920 Metric Series Inner Ring, 15 mm ID x 19 mm OD, 20 mm OAW, For Use With TAF192720 Machined Type Needle Roller Bearing, High Carbon Steel
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Metric-type LRT series Inner Rings have shaft diameters from 5 to 440 mm.
CLC® 439 Steel Loop Hammer Holder, 5-3/4 in H x 4 in W x 2-5/8 in D, Top Grain Leather, Tan
1/2" SCH-80 GLUE-ON CPVC CAPS-NIB1847005 >
