MORSE® 42062 1880 Center Cutting Regular Length Single End End Mill, 7/8 in Dia Cutter, 1-7/8 in Length of Cut, 3 Flutes, 3/4 in Dia Shank, 4-1/8 in OAL, Bright
MORSE® 42062 1880 Center Cutting Regular Length Single End End Mill, 7/8 in Dia Cutter, 1-7/8 in Length of Cut, 3 Flutes, 3/4 in Dia Shank, 4-1/8 in OAL, Bright
-
BrandMORSE®
-
UPC686125420628
-
Manufacturer Part Number42062
-
CountryUSA
-
FinishBright
-
MaterialHSS
-
Flute TypeSpiral
-
TypeCenter Cutting Regular Length Single End
-
Helix Angle30 deg
-
Series1880
-
Cutter Diameter7/8 in
-
Shank Diameter3/4 in
-
Number of Flutes3
-
Cutting DirectionRight Hand
-
Shank TypeRound/Weldon Flat
-
Length of Cut1-7/8 in
-
Overall Length4-1/8 in
- Provides a compromise between the chip capacity of 2-flute end mills and the improved surface finish, greater core strength and higher feed rate of multi-flute end mills
- Allows for plunge cutting like a drill into solid materia
-
UNSPSC23242511
-
Package Description1/PK
-
Standards/ApprovalsISO 9001:2008
Recently Viewed
MORSE® 42062 1880 Center Cutting Regular Length Single End End Mill, 7/8 in Dia Cutter, 1-7/8 in Length of Cut, 3 Flutes, 3/4 in Dia Shank, 4-1/8 in OAL, Bright
MORSE® 42062 1880 Center Cutting Regular Length Single End End Mill, 7/8 in Dia Cutter, 1-7/8 in Length of Cut, 3 Flutes, 3/4 in Dia Shank, 4-1/8 in OAL, Bright
Red Devil® DIY® 106370 Ball End Glass Cutter, 5 in OAL
MORSE® 59020 5968 Center Cutting High Performance Regular Length Single End End Mill, 1/2 in Dia Cutter, 0.03 in Corner Radius, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, Bright
MORSE® 59020 5968 Center Cutting High Performance Regular Length Single End End Mill, 1/2 in Dia Cutter, 0.03 in Corner Radius, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, Bright
Proto® J795A Wrench Set, 3 Pieces, 8 in, 10 in, 12 in, Satin
DOUBLE SEALED WIDE BALL BEARINGS-FAFW308PP>
Shaft support blocks are used for end or intermittent support where loads are light and deflection between supports is not a problem. Unlike shaft support rails, blocks do not permit longitudinal passage of open-type Ball Bushing® bearings. Type SB shaft support blocks enable clamping of shafts and eliminate the need for bolts, to maintain shaft position. Shimming is suggested for high-precision applications to eliminate the effect of variations in surface of base or manufacturing tolerances between supports.
