MORSE C/Tool 1/2" 4-FL SE CC ROUGHING ENDMILLS MCT 92366
MORSE® 92366 5929T Center Cutting Regular Length Single End End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, TiAlN Coated
-
BrandMORSE®
-
UPC686125923662
-
Manufacturer Part Number92366
-
CountryUSA
-
FinishTiAlN Coated
-
MaterialSolid Micrograin Carbide
-
TypeCenter Cutting Regular Length Single End
-
Series5929T
-
Cutter Diameter1/2 in
-
Shank Diameter1/2 in
-
Number of Flutes4
-
Cutting DirectionRight Hand
-
Shank TypePlain/Round
-
Length of Cut1 in
-
Overall Length3 in
- Chipbreaker geometry permits high feed rates in roughing operations while producing a finish near that produced by standard end mills
- Benefits include smaller more manageable chips and reduced cutting forces, chatter, deflection and horsepower required
- Increased productivity with longer tool life
- Recommended for aggressive milling in stainless steels, difficult-to-machine materials and wide range of other materials
- Solid carbide offers higher cutting speeds, high rigidity, excellent hardness, wear resistance and heat resistance and long tool life
- Titanium aluminum nitride coating is an excellent all around coating that increases surface hardness, wear resistance, heat resistance, chip flow and resist chip welding
-
UNSPSC23242511
-
Package Description1/PK
-
Standards/ApprovalsISO 9001:2008
Recently Viewed
MORSE® 92366 5929T Center Cutting Regular Length Single End End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 3 in OAL, TiAlN Coated
FHP V-BELT-JAS5L890>
FINISHING PADS-JWH771759>
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
Browning® 1073766 Type F Q-D® Bushing, 1-3/4 in Dia Bore, 4-3/8 in Dia Barrel, 6-5/8 in Dia Flange, 3.68 in OAL, Cast Iron
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
DRAWN CUP CLUTCH NEEDLE BEARING - TORRC162110>
