T.B. Woods 1-5/8"-ID S-FLEX COUPLING HALFS TBW 9-S-1-5/8
Type S flanges sizes 6 through 16 are manufactured of high strength cast iron then bored-to-size for slip fit on standard shafts. Size 5 is made of sintered carbon steel. Flanges are easy to install and remove, and are stocked in a wide range of bore sizes. All sleeve materials may be used with type S flanges.
-
BrandTB Wood's®
-
UPC698672640725
-
Manufacturer Part Number9S158
-
CountryUSA
-
MaterialCast Iron
-
Maximum Speed3750 rpm
-
TypeBore-To-Size Type S
-
Screw Size3/8-16 UNC x 3/4 in L Setscrew
-
Coupling Size09
-
Hub Diameter3-5/8 in
-
Hub Length25/32 in
-
Keyway Size3/8 x 3/16 in
-
Length Through Bore2-13/32 in
-
Bore Diameter1-5/8 in
-
UNSPSC31163000
-
Standards/ApprovalsATEX Compliant|PROP65: This product contains lead, known to the State of California to cause cancer and birth defects or other reproductive harm.
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
Type S flanges sizes 6 through 16 are manufactured of high strength cast iron then bored-to-size for slip fit on standard shafts. Size 5 is made of sintered carbon steel. Flanges are easy to install and remove, and are stocked in a wide range of bore sizes. All sleeve materials may be used with type S flanges.
Gates® Power Transmission Super HC® Molded Notch PowerBand® 4/5VX1400 Heavy Duty Molded Notch V-Belt, 5VX Section, 5/8 in W Top, 140 in L Outside, 35/64 in THK, EPDM
When your power transmission application needs a high horsepower solution but is constrained by drive weight or physical space, the answer is Super HCâ„¢ Molded Notch belts. Our proprietary ethylene construction process provides a superior combination of flex and load-carrying capacity, transmitting up to three times the horsepower versus comparably sized belts. Super HC MN V-belts put more power where high speeds, high speed ratios or small pulley diameters are required, offering significant benefits over classical section V-belts.
84" VERTICAL SCHULTE SHELVING POLE-JWH217905>
BUGLE HEAD COARSE THREAD. FOR ATTACHING GYPSUM BOARD TO WOOD STUDS. NO. 2 REDUCED PHILLIPS RECESS. THIS SCREW IS CONSTRUCTED OF HARDENED STEEL WHICH IS THE RESULT OF CARBON STEEL BEING PUT THROUGH HEAT TREATMENT, QUENCHING, NAD FURTHER REHEATING MAKING IT EXTREMELY DURABLE. HARDENED STEEL IS MORE RESISTANT TO WEAR, CORROSION, AND ABRASION.
-JWH701386 >
Type J flanges sizes 3, 4 and 5 are manufactured of sintered carbon steel. The powdered metal manufacturing process provides high dimensional accuracy and uniform material properties for high strength. Size 6 is made of high strength cast iron. Flanges are bored-to-size for a slip fit on standard shafts. The outside face of the flange is precision machined, allowing the surface to be used to align the coupling without special tools.
