202 Enamel Universal Gray Spray
ENAMEL UNIVERSAL GRAY SPRAY PAINT-PLA202 >
Recently Viewed
ENAMEL UNIVERSAL GRAY SPRAY PAINT-PLA202 >
Greenlee® 767 1-Speed Manual Hydraulic Hand Pump, 0.0823 cu-in Pump
Greenlee® 767 1-Speed Manual Hydraulic Hand Pump, 0.0823 cu-in Pump
Magnolia Brush 2024 General Purpose Floor Broom With M-60 Handle, 3 in L Trim, Black Plastic Bristle
Magnolia Brush 2024 General Purpose Floor Broom With M-60 Handle, 3 in L Trim, Black Plastic Bristle
Leviton® 515CA Cable Mount Armored Grounding Straight Blade Connector, 125 V AC, 15 A, 2 Poles, 3 Wires, Yellow
Leviton® offers a large selection of 15, 20, 30 and 50 A commercial grade straight blade plugs and connectors, available in a wide variety of features. These rugged performers are moisture, chemical and abuse resistant and they are ideal for indoor and outdoor use. Our EPTR rubber backed plugs and connectors stand up to rough use, protecting against dirt and moisture. The deep slotted, backed out terminal screws draw back wire clamps securely over stripped leads for maximum conductivity.
Magnolia Brush 1424 Garage Broom With B-60 Handle, 4 in L Trim, Brown Palmyra Bristle
Magnolia Brush 1424 Garage Broom With B-60 Handle, 4 in L Trim, Brown Palmyra Bristle
Browning® 3779949 VP Series Type 2 Variable Pitch Sheave, 1-3/8 in Finished Bore, 6.55 in OD, 1 Groove, 4.9 to 5.9 in (A/4L)/5.2 to 6.4 in (B/5L/5V) Dia Pitch, 7/8 to 1-1/4 in W Face
The principle of a variable pitch sheave is that the threaded angular faced discs forming the V-shaped groove in which the belt rides are movable. VP sheaves consist of a male with a threaded barrel, and a female with a threaded bore. The male section with threaded barrel has flat surfaces at 180 deg increments that allow a flat surface for the setscrew to mate with. When the discs are moved toward each other, the belt rides higher in the groove and the pitch diameter of the sheave is larger which increases the driven speed. When the discs are moved away from each other, the belt rides lower and the pitch diameter is smaller decreasing the driven speed. The common term for this speed adjustment is called number of turns open from closed position.
