Gates® Power Transmission Polyflex® 11M775 Light Duty V-Belt, 11M Section, 7/16 in W Top, 30.51 in L Outside, 9/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
-
BrandGates® Power Transmission
-
UPC72053225266
-
Manufacturer Part Number11M775
-
CountryUSA|Canada
-
Temperature Range-65 to 180 deg F
-
Thickness9/32 in
-
MaterialHigh Modulus Polyurethane
-
Top Width7/16 in
-
Reinforced MaterialPolyester
-
TypeLight Duty
-
Minimum Pulley Diameter3.82 in
-
Section Size11M
-
Series8904
-
Number of Ribs1
-
Outside Length30.51 in
- High modulus polyurethane compound resists fatigue, wear, ozone and most environmental conditions
- Precise casting method eliminates layers and overlaps for smooth running and low vibration
- Ribbed backing provides greater lateral stability and relieves bending stress
- Unique 60 deg angle polyurethane construction transmits greater loads at higher speeds in less space than conventional V-belts
-
Alternative Part Number89040775
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsRMA Standard
-
Instruction/Installation Manual
-
Specification Sheet
-
Catalog
Recently Viewed
Gates® Power Transmission Polyflex® 11M775 Light Duty V-Belt, 11M Section, 7/16 in W Top, 30.51 in L Outside, 9/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
Finding a belt that fits into your compact machinery without sacrificing power or efficiency is a daily challenge. When every inch of space is precious and traditional belts just don't cut it, the Super HC Molded Notch (MN) V-belt is your solution. This bandless, high-performance belt, crafted from ethylene elastomer with precision-molded notches, provides superior cord support and flexibility to improve load distribution and reduce maintenance needs. Whether you aim to boost your drive efficiency or minimize downtime, Gates Super HC MN V-belts deliver the durability and performance to keep your industrial processes running smoothly.
Sealmaster® 703378 SEHB Non-Expansion Standard-Duty Hanger Ball Bearing Unit, 1 in Dia Bore, 3-1/8 in OD, 1-1/2 in W, Cast Iron Bearing, Set Screw Collar Locking
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing and lubrication options or industry specific solutions.
15/16" -ID LOW PILLOW BLOCK UNIT-FYHEASL20515 >
7/8" LIFT ARM PIN-HIG03000 >
SATIN BLACK RUST COAT SPRAY ENAMEL-JWH773164>
