IKO Bearings THRUST NEEDLE BEARINGS IKO NTB-6085
IKO designs and manufactures thrust bearings with precisely machined cages and rollers to handle high axial loads in confined spaces. Two styles are available - thrust needle roller bearings and thrust roller bearings. Thrust Needle Roller Bearings feature needle type rollers and cages made from precisely formed, surface hardened steel plates.
-
BrandIKO
-
Manufacturer Part NumberNTB6085
-
CountryUSA
-
Load Capacity38200 N Dynamic/219000 N Static
-
Maximum Speed3500 rpm
-
Width3 mm
-
SeriesNTB Metric Series
-
Number of Rows1
-
Bearing MaterialHardened Steel
-
Outside Diameter85 mm
-
Bore Diameter60 mm
- Rigid structure and good lubricant capacity
- Lowest sectional height of all thrust bearings
- Suitable replacement for thrust washers
- Withstands high-speed rotations with a low coefficient of friction
-
UNSPSC31171553
-
Catalog
Recently Viewed
IKO designs and manufactures thrust bearings with precisely machined cages and rollers to handle high axial loads in confined spaces. Two styles are available - thrust needle roller bearings and thrust roller bearings. Thrust Needle Roller Bearings feature needle type rollers and cages made from precisely formed, surface hardened steel plates.
2" YELLOW PLASTIC QUICK LINKS-TCI07262 >
12 TOOTHHHN GREEN ELECTRICAL WIRE (FT)-ALE12THHNGRNSOLID >
1/2" X 18" REDI-CUT BLACK PIPE IS THREADED AND HAS THREAD PROTECTOR AT BOTH ENDS. THIS PIPE IS AVAILABLE ON DIRECT ORDERS IN GALVANIZED OR BLACK PIPE. SIZES AVAILABLE ARE 3/8" TO 2" IN 18" TO 60" LENGTHS IN 6" GRADUATIONS-JWH410102 >
IKO designs and manufactures thrust bearings with precisely machined cages and rollers to handle high axial loads in confined spaces. Two styles are available - thrust needle roller bearings and thrust roller bearings. Thrust Needle Roller Bearings feature needle type rollers and cages made from precisely formed, surface hardened steel plates.
The Glasfloss PTA shall be constructed of a single piece of heavy-duty, one piece craftboard frame. The metal grid shall be thermally bonded internally to the frame. The metal grids shall provide an 82 percent open area. All corners shall be closed and sealed. The filter media shall be constructed in a progressively dense fashion from air entertaining to air-leaving side. Glasfloss disposable panel filters shall be rated to withstand temperatures up to 180 degrees Fahrenheit. All filters shall be classified under U.L. std. 900.
