IKO Bearings 2-3/4"-ID NEEDLE BEARINGS IKO BA-4420-Z-OH
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
-
BrandIKO
-
Manufacturer Part NumberBA4420ZOH
-
CountryUSA
-
Load Capacity54600 N Dynamic/139000 N Static
-
Maximum Speed3500 rpm
-
Closure TypeOpen
-
Bearing MaterialChromium Molybdenum Steel
-
Bore Diameter2-3/4 in
- Caged bearings for high-speed rotation feature precise needle rollers, accurately guided by a cage and thrust rings
-
UNSPSC31171512
-
Catalog
Recently Viewed
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
Browning® Gearbelt® 1054782 Type 1 Synchronous Timing Pulley With Flange, 5/8 in Finished Bore, 1.88 in OD, 16 Grooves, 1.91 in Dia Pitch, 1-1/4 in W Face
Synchronous belt drives help reduce the problems of slippage, belt stretch, lubrication and metal to metal contact. They provide superior performance because power is transmitted by positive engagement of belt teeth rather than by friction, as in conventional belt drives.
CM® 4X1304 Latch Kit, 1-21/32 in L x 0.63 in W, 2 ton Working Load Limit (Alloy), 1-1/2 ton Working Load Limit (Carbon), For Use With Herc-Alloy® 800 or 1000 Swivel Rigging Hooks, Steel, Zinc Plated
Gator® GatorGrit 3277 Coated Sanding Sheet, 11 in L x 9 in W, 80 Grit, Garnet Abrasive, Paper Backing
Gator® GatorGrit 3277 Coated Sanding Sheet, 11 in L x 9 in W, 80 Grit, Garnet Abrasive, Paper Backing
Worms and worm gears are used to power right angle, nonintersecting shafts. In normal applications the worm gear is driven by the worm. The most popular use of worms and worm gears is in applications where high ratio speed reduction is desired in a relatively limited space. They are also used in applications where high resistance to the worm gear shaft reversing and driving back through the worm is desired.
Mayhewâ„¢ 21004 PROâ„¢ Pin Punch, 3/16 in Hex Punch, 5-1/4 in OAL, Alloy Steel
