Torrington 1-1/2"-OD YOKE CAM FOLLOWERS TOR YCRS-24
Track rollers (also known as cam followers) are characterized by their thick-walled outer rings that run directly on a track. The thick outer rings permit high load-carrying capability while minimizing both distortion and bending stresses. Sealed designs with internal thrust washers help extend service life under conditions of infrequent lubrication.
-
BrandKoyo
-
UPC605790197475
-
Manufacturer Part NumberYCRS-24
-
CountryUSA
-
Load Capacity4530 lbf Dynamic/6460 lbf Static
-
Temperature Rating-25 to 225 deg F
-
FinishBlack Oxide
-
Maximum Speed2700 rpm Grease
-
Closure TypeSealed
-
TypeUncaged Yoke Type
-
Roller Diameter1-1/2 in
-
Roller Width7/8 in
-
SeriesYCRS Inch Series
-
Bore Diameter7/16 in
-
Overall Width15/16 in
- Non-separable unit with outer ring, a full complement of needle rollers, inner ring, self-lubricating resin internal thrust washers and two retaining washers securely fastened to the inner ring
- Tolerance limits for outer diameters of stud and outer ring refer to
- Seals in counter bores of outer ring seal against the retaining washers, retain lubricant and exclude foreign matter
- High load-carrying capability with minimized distortion and bending stresses
- Extended service life under conditions of infrequent re-lubrication
-
Alternative Part NumberYCRS24PBL449
-
UNSPSC31171541
-
Standards/ApprovalsANSI/ABMA 18.2
-
Catalog
Recently Viewed
Track rollers (also known as cam followers) are characterized by their thick-walled outer rings that run directly on a track. The thick outer rings permit high load-carrying capability while minimizing both distortion and bending stresses. Sealed designs with internal thrust washers help extend service life under conditions of infrequent lubrication.
4" X .008 WIRE WITH 1/4" HEX SHANK FINE WIRE WHEEL-FOR72740 >
3" COARSE WIRE WHEEL BRUSHES - Shank: 1/4 in (6.35 millimeters) - Wire Size: .014 in (0.356 millimeters) - Material: Steel - Maximum Revolutions per Minute (RPM): 15,000 - Tool Type: For use with any 1/4 in diameter power drill or die grinder
BRASS BRUSH SET 2-piece brass brush set. Ideal for cleaning of rust and dirt.
P-1-STYLE IDLER BUSHING-BRWIDP15/8 >
National Hardware® N266-379 SP115BC Corner Braces, 2 in L x 5/8 in W x 0.11 in H, 4 Holes, Hot Rolled Steel
