Loctite 3-OZ TUBE #2 GASKET SEALER LOC 30514
LOCTITE® MR 5922 is a black, viscous, solvent-based, slow drying, flexible setting that changes to a pliable, non-hardening film through solvent evaporation. It is based on resin, isopropanol and fillers. It seals flanges, fittings, connections and flexible assemblies against leakage. It increases the reliability of gasket and can be used for pre-cut gaskets.
-
BrandLoctite®
-
UPC079340305144
-
Manufacturer Part Number234891
-
CountryCanada
-
Temperature Rating-65 to 400 deg F
-
Chemical TypeSolvent
-
ColorBlack
-
TypeFlexible Cure Slow Dry
-
VOC Content0.003
-
Container Size3 oz
-
Adheres toCork, Metal, Plastic and Rubber
-
Container TypeTube
-
Specific Gravity1.55
-
Drying Time4 hr
- Gasket sealant 2 extended gasket life, slow-drying, flexible cure
- Sets more slowly to a pliable film best suited for non-rigid, vibrating assemblies
- Use to 400 deg F resistant to gasoline and other solvent
| Competitor Name | Cross-Reference Number |
|---|---|
| Grainger | 2EMY2 |
-
Alternative Part Number30514
-
UNSPSC31201700
-
Package Description1/PK
-
Catalog
Recently Viewed
LOCTITE® MR 5922 is a black, viscous, solvent-based, slow drying, flexible setting that changes to a pliable, non-hardening film through solvent evaporation. It is based on resin, isopropanol and fillers. It seals flanges, fittings, connections and flexible assemblies against leakage. It increases the reliability of gasket and can be used for pre-cut gaskets.
This combination unit features the 4203 adjustable position, variable speed base and the 4262-1 3/4 in. drill motor. All you need is a bit and you are ready to drill into any ferrous material 1/2 in. and thicker.
This combination unit features the 4203 adjustable position, variable speed base and the 4253-1 1/2 in. drill motor. All you need is a bit and you are ready to drill into any ferrous material 1/2 in. and thicker.
This combination unit features the 4202 fixed position variable speed base and the 4262-1 3/4 in. drill motor. All you need is a bit and you are ready to drill into any ferrous material 1/2 in. and thicker.
