SAIT 3/8" B-52 MOUNTED POINTS SAI 27110
United Abrasives-SAIT 27110 Mounted Point, B52, 3/8 in Dia x 3/4 in L Head, 1/8 in Dia Shank
-
BrandUnited Abrasives-SAIT
-
UPC699053271101
-
Manufacturer Part Number27110
-
CountryUSA|Canada
-
Maximum Speed45370 rpm
-
GradeVery Fine
-
GritA60
-
Abrasive MaterialAluminum Oxide
-
Head Diameter3/8 in
-
Head Length3/4 in
-
Shank Diameter1/8 in
-
Shank Length1-1/2 in
-
Bond TypeVitrified Porous
-
Overall Length2-1/4 in
- These mounted bonded points are a low cost alternative to carbide burs
- Each point is dressed for perfect balance to perform without vibration or run out
- Mandrel overhang
- Maximum speeds given refer to overhang
- For use with die grinders
| Competitor Name | Competitor Part Number |
|---|---|
| Fastenal | 4020-27110 |
-
UNSPSC23131514
-
Package Description20/BX
-
Standards/ApprovalsOSHA 29 CFR 1910.1200
-
SDS
Recently Viewed
United Abrasives-SAIT 27110 Mounted Point, B52, 3/8 in Dia x 3/4 in L Head, 1/8 in Dia Shank
IDC Select® IDC H80B15F-2 Finished Bore Type B Single Strand Roller Chain Sprocket, 2 in Dia Bore, 5.3 in OD, 80 Chain, 15 Teeth, 1 in Pitch, C1045 Steel
IDC Select® offers a wide range of high quality roller chain sprockets produced in ISO certified facilities to ANSI standards. Plain bore, finished bore, taper and QD® bushing designs are available. All IDC Select® sprockets come with hardened teeth and black oxide finish for long lasting service life. The finished bore design comes complete with a keyway on the centerline of the sprocket tooth and two setscrews, one over the keyway and one at 90 deg.
MORSE® 51086 5374 Standard Length Jobber Length Drill Bit, #7 Drill - Wire, 0.201 in Drill - Decimal Inch, 118 deg Point, Solid Carbide, Bright
MORSE® 51086 5374 Standard Length Jobber Length Drill Bit, #7 Drill - Wire, 0.201 in Drill - Decimal Inch, 118 deg Point, Solid Carbide, Bright
The DEWALT DWA5101 3/16" X 4" X 6" Impact Ready Masonry Bit features an innovative flute design leading to faster material removal for easier drilling. It offers a speed tip which penetrates material quickly. Designed with a 1/4" hex shank for use in impact drivers. Commonly used for tap con installation, and brick/block fastening.
MORSE® 98509 7501G General Purpose Spiral Point Tap, M8x1.25 Thread, D5 Thread Limit, Plug Chamfer, 2 Flutes, TiN Coated, HSS
MORSE® 98509 7501G General Purpose Spiral Point Tap, M8x1.25 Thread, D5 Thread Limit, Plug Chamfer, 2 Flutes, TiN Coated, HSS
JIGSAW BLADE--CARD OF 5-BSHT111C >
