MORSE® 59574 5970 Premium Carbide Burr, Radius End, Tree Head, 1/2 in Dia Head, 1 in L of Cut, 2-1/2 in OAL, Double Cut
MORSE® 59574 5970 Premium Carbide Burr, Radius End, Tree Head, 1/2 in Dia Head, 1 in L of Cut, 2-1/2 in OAL, Double Cut
-
BrandMORSE®
-
UPC686125595746
-
Manufacturer Part Number59574
-
CountryUSA
-
Maximum Speed36000 rpm
-
TypePremium
-
Head CoatingBright
-
Head Diameter1/2 in
-
Head MaterialSolid Carbide
-
Head ShapeTree
-
Applicable MaterialsBrass, Cast Iron and Copper
-
Series5970
-
Cut TypeDouble
-
Shank Diameter1/4 in
-
Included Angle45 deg
-
Industry SpecificationSF-5
-
End TypeRadius
-
Length of Cut1 in
-
Overall Length2-1/2 in
- Design reduces the pulling action, reduces size of chips
-
UNSPSC23251706
-
Package Description1/PK
-
Standards/ApprovalsPROP65: This product contains a chemical known to the State of California to cause cancer or Birth defects. For more information go to www.P65Warnings.ca.gov
-
Catalog
Recently Viewed
MORSE® 59574 5970 Premium Carbide Burr, Radius End, Tree Head, 1/2 in Dia Head, 1 in L of Cut, 2-1/2 in OAL, Double Cut
MORSE® 59574 5970 Premium Carbide Burr, Radius End, Tree Head, 1/2 in Dia Head, 1 in L of Cut, 2-1/2 in OAL, Double Cut
Browning® 3748464 Taper Lock Bushing, 1/2 in Dia Bore, 1.511 in Dia Barrel, 7/8 in OAL, Steel
Diablo® DS1208CF3 Reciprocating Saw Blade, 12 in L, 8 TPI
Koyo IR-2424 Inch Series Regular Width Inner Ring, 1-1/2 in ID x 1-3/4 in OD, 1.515 in OAW, For Use With Inch Series Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
DOUBLE OPEN FACE BALL BEARING-IDCR14 >
Jacobs® 30605 L-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: KGA, For Use With 1/4 in and 3/8 in Multi-Craft® Chucks, Soft Steel
Jacobs® 30605 L-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: KGA, For Use With 1/4 in and 3/8 in Multi-Craft® Chucks, Soft Steel

