HCI PREFERRED SUPPLIER

1/16" X 1/8" COATED AIRCRAFT CABLE (FT)-TCI23002 >

2-3/4" URETHANE-FACE HAMMERS-GAR23005>

7/16" TAP SET-FTS2300553>

1/2" TAP SETS-FTS2300573>

1/8" RED VINYL COATED CABLE 7X19 TOOTHCI23006R >

7/8" TAP SETS-FTS2300774>

1"-12 TAP SET-FTS2300834>

1"-14 TAP SET-FTS2300854>

CLEAR UPSIDE DOWN MARKING SPRAY PAINT-RUS2301 >

2" X 360" 2-PLY TWISTED-EYE NYLON SLING - SWC23021 >

STR-ID SPHERICAL ROLLER BEARINGS-SNR23024>

7/16" TAP-FTS2302553>

1/2" TAP SET-FTS2302593>

STR-ID SPHERICAL ROLLER BEARINGS-SNR23026>

STRAIGHT-ID SPHERICAL ROLLER BEARING-GUL23028 >

TPR-ID SPHERICAL ROLLER BEARINGS-SNR23028K>

OIL SEALS-2.313" X 2.997" X .375"-IMS23030>

Radial shaft seal with metal case and SKF Wave lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
For oil or grease
With garter spring
WAVE lip creates higher pumping rate
WAVE lip has less friction between shaft and lip
WAVE lip has a lower temperature at the contact point

TPR-ID SPHERICAL ROLLER BEARINGS-SNR23030K>

Inner Diameter (Bore): 150 mm Outer Diameter: 225 mm Width: 56 mm Bore Type: Tapered (K = taper 1:12) Design Features: Self-aligning, accommodates heavy radial and axial loads in both directions, typically includes an annular lubrication groove with three holes in the outer ring (W33 variant).

STR-ID SPHERICAL ROLLER BEARINGS-SNR23030>

STRAIGHT-ID SPHERICAL ROLLER BEARING-GUL23034 >

TPR-ID SPHERICAL ROLLER BEARING-GUL23034K >

TPR-ID SPHERICAL ROLLER BEARING-GUL23036K >