HCI PREFERRED SUPPLIER

7/8" SOLID SHAFT COLLAR

7/8" -ID JAW COUPLING HALVES

RETAINING RINGS ARE PRECISION-ENGINEERED COMPONENTS, WHICH WHEN APPLIED IN BORES PROVIDES A SHOULDER THAT ACCURATELY POSITIONS, LOCATES OR RETAINS OTHER PARTS OF AN ASSEMBLY. THEY CAN BE USED TO REPLACE PINS AND WASHERS, THREADED SECTIONS, COLLARS, MACHINE SHOULDERS, AND OTHER COSTLY OR TIME-CONSUMING METHODS

CONSTRUCTED AS CURVED BEAMS OF UNIFORM STRENGTH, THE RADIAL WIDTH IS REDUCED TOWARDS THE FREE ENDS SO THAT A CONSTANTLY ROUND SHAP IS MAINTAINED THROUGHOUT CONTINUOUS USE. THIS FORM OF CIRCLIP OFTEN USED IN ASSEMBLIES SUBJECTED TO STRONG CENTRIFUGAL FORCES, IS ALSO SECURE AGAINST HIGH ROTATIONAL SPEEDS. LUGS WITH HOLES ARE PROVIDED FOR RAPID FITTING OR REMOVAL WITH CIRCLIP PLIERS.

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

A 7/8-inch A2 drill rod is an air-hardening, precision-ground tool steel round bar commonly used for punches, shafts, and dies.

7/8" IWRC IMPORTED WIREROPE (FT)-SWC7890 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78500 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78200 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78150 >

7/8" X 36" O-1 OILHARD DRILLROD-DRI7/801 >

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

7/32" X 36" O-1 OILHARD DRILLROD-DRI7/32O1 >

7/32" CHAINSAW FILE #168-8-5.5-1P-WIN732 >

7/16" -ID SOLID SHAFT COLLARS

7/16"-ID STAINLESS STEEL SHAFT COLLAR

RETAINING RINGS ARE PRECISION-ENGINEERED COMPONENTS, WHICH WHEN APPLIED IN BORES PROVIDES A SHOULDER THAT ACCURATELY POSITIONS, LOCATES OR RETAINS OTHER PARTS AND ASSEMBLY. THEY CAN BE USED TO REPLACE PINS AND WASHERS, THREADED SECTIONS, COLLARS, MACHINE SHOULDERS, AND OTHER COSTLY OR TIME-CONSUMING METHODS

CONSTRUCTED AS CURVED BEAMS OF UNIFORM STRENGTH, THE RADIAL WIDTH IS REDUCED TOWARDS THE FREE ENDS SO THAT A CONSTANTLY ROUND SHAP IS MAINTAINED THROUGHOUT CONTINUOUS USE. THIS FORM OF CIRCLIP OFTEN USED IN ASSEMBLIES SUBJECTED TO STRONG CENTRIFUGAL FORCES, IS ALSO SECURE AGAINST HIGH ROTATIONAL SPEEDS. LUGS WITH HOLES ARE PROVIDED FOR RAPID FITTING OR REMOVAL WITH CIRCLIP PLIERS

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

7/16" 2-PIECE CLAMP SHAFT COLLAR

7/16" IWRC IMPORTED WIREROPE (FT)-SWC7/1698 >

7/16" IWRC IMPORTED WIREROPE (FT)-SWC71646 >

7/16" IWRC IMPORTED WIREROPE (FT)-SWC716250 >

7/16" IWRC IMPORTED WIRE ROPE 200(FT)-SWC7/16200 >