Busway Fusible Plug Units
Square Dâ„¢ PQ3620G Type PQ Ii Busway Fusible Plug-In, 277/480 V AC, 200 A, 4 Wires, FS Frame, NEMA 1 Enclosure
I-Line Busway offers a complete line of compatible, sandwich-type feeder and plug-in busway lengths, fittings, and plug-in units. I-Line plug-in busway has options to 1600A for circuit breaker plug-ins and 1200A for fusible plug-ins. Circuit breaker and fusible plug in units are available in 3 phase, 3 wire or 3 phase, 4 wire configurations. This fusible plug-in unit is 200A, 600VAC max, 3 pole, and 3 fuse + G. This unit uses a plug in connection. This plug-in unit accepts H, K, J or R fuses. I-Line Busway plug in units are UL listed and CSA certified.
Recently Viewed
Browning® 1296615 T65L Automatic Torque Limiter, 1-15/16 in Finished Bore, 6-1/2 in OD, 4800 in-lb (1-Spring)/8800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
1-1/16" -ID 1-3/16" -OD VITON O-RING
3.438" X 4.756" X .438"RADIAL SHAFT SEAL WITH DOUBLE METAL CASE, SKF WAVE LIP, FOR OIL OR GREASE
1" -ID REINFORCED VINYL TUBE (FT)-M-MHOSE2260 >
TCM08111VM>
GENERAL APPLICATIONSSaturated steam applications up to 270 PSI and 410°FThawing and de-icing of outdoor pipes and other equipment during cold temperaturesHigh pressure industrial equipment cleaning at refineries, processing plants and shipyardsCONSTRUCTIONTube — Black, conductive EPDM.Reinforcement — Single high tensile steel wire braid (1/2" Size), Two high tensile steel wire braids (3/4" to 3"). Cover — Red or black pin-pricked EPDM.SERVICE TEMPERATURE RANGE-40°F (-40°C) to +410°F (+2 1 0°C)BRANDINGALFAGOMMA ITALY T3 4 0 18 BAR (2 7 0 PSI) STEAM - DRAIN AFTER USEFEATURES AND ADVANTAGESHighest Pressure Capabilities — Handles pressures up to 270 PSI, higher than other steam hoses which range up to 250.Pin Pricked Cover — Vents trapped vapors to help prevent "popcorning."Heat Resistant — Specially formulated, heat resistant EPDM tube and cover. Capable of transferring saturated steam up to +410°FConductive Tube — Helps dissipate potential charge to ground, reducing the risks of shocks.Highly Durable Cover — Heat, weathering, abrasion and ozone resistant cover designed to perform in highly demanding, steam hose applications.
