Conduit Bodies - Type X
Appleton® UNILETS™ X75A Type X Conduit Outlet Body, 3/4 in Hub, Form 85, 7 cu-in, Sand Cast Aluminum, Epoxy Powder Coated
Appleton® Form 85™ UNILETS™ Conduit Outlet Bodies, Covers and Gaskets are used to connect and change direction of conduit runs. In addition to making bends in a conduit system, they allow connections for branch runs. These conduit bodies serve as pulling fittings and permit access to conductors for splicing and maintece.
Carlon® E970CE Type X Non-Metallic Round Conduit Body With Cover, 3/4 in Hub, 15.16 cu-in Capacity, PVC
Carlon® E970CE Type X Non-Metallic Round Conduit Body With Cover, 3/4 in Hub, 15.16 cu-in Capacity, PVC
Recently Viewed
Reamer locks onto screwdrivers, reams and smooths thin-wall conduit
Reams ID and OD at the same time
Two set-screws to fit round- or square-shank screwdrivers
Fits up to 3/8-Inch (10 mm) keystone-tip screwdrivers
Made in USA
NOT for use on power tools
Designed to be used on Electrical Metallic Tubing (EMT)
#12-1/2" -STUD RING WIRE TERMINALS-DEL853505 >
9-WATT 2-PIN TWIN TUBE FLUORESCENT BULBS #02740-B-BULF9TT/827 >
Milwaukee® Tapcon™ 48-20-7091 2-Cutter Rotary Hammer Drill Bit With 1/4 in Hex Shoulder, 5/32 in Drill Bit, 1/4 in SDS Shank, 4 in D Cutting, Carbide Cutting Edge, 7 in OAL
The Milwaukee® SDS Plus bits with 1/4 in. hex are designed specifically for TAPCON® screw applications. Built to take on brick, block, and concrete Milwaukee SDS Plus Bits feature 2-cutter geometry for fast drilling and debris removal. The patented, reinforced flute design increases impact resistance and transfers energy directly to the bit tip. Patented rebar chamfers withstand impact from rebar and hard aggregate, and reduce Carbide chipping. To be used with drive sleeve available in the SDS Plus TAPCON® installation kit (48-20-7497). TAPCON® is a registered trademark of Illinois tool works Inc.
100' FIBERGLAS FISHTAPE-GRN540100 >
Double-duty hammer drives lags and pulls big nails
Special high-carbon steel head with solid driving end and thick, strong claw
Straight-grain hickory handle, lacquered
Heavy-duty design manufactured specifically with lineworkers in mind
Made in USA
Longer, curved claw provides more leverage for pulling out hardware
Larger strike face provides increased surface area for better contact
