8"
Recently Viewed
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Metric-type LRT series Inner Rings have shaft diameters from 5 to 440 mm.
The 92-89 cable hook and V-rung assembly functions as both cable hook and V-rung. For use in applications where the diameter of the pole at the point of support does not exceed 10 in. Steel V-rung has rubber pad for slip resistant performance. One cable hook and V-rung assembly, mounting hardware and instructions are included.
SINGLE GROOVE VARIABLE PITCH SHEAVES 56X3/4 -BRW1VP56X3/4 >
3" 6-TPI WOOD JIGSAW BLADE-POR12306 >
MURRAY IDLER 3-1-1/32" X 1/2-MED34826 >
Browning 20-TOOTH #50-1 CHAIN SPROCKETS BRW H-5020 X 1-1/8
Browning® finished bore sprockets are offered in single strands. Offerings include 35 to 100 pitch range. Finished bore sprockets are available from 3/8 to 2-7/16 in. Hardened teeth are available up to 30 teeth.
